Denison Hydraulics Goldcup 6, Инструкция по установке и капитальному ремонту, Страница: 11 / 24

SECTION V – ASSEMBLY PROCEDURES
DRIVE SHAFT ASSEMBLY 1. Pass one retaining ring (3) over the internal end of drive shaft (1) and install in the
Figure 1 groove near the shaft seal surface.
DO NOT PASS THE RING OVER THE SEAL SURFACE.
2. Slide the bearing (2) over the same end of the shaft and seat against the ring.
Support only the inner race of the bearing and press on the coupling end of the
shaft.
DO NOT USE EXCESSIVE FORCE AND DISTORT OR DAMAGE THE RETAINING
PIN.
3. Install the other retaining ring (3) in the other retaining ring groove. Be sure that both
rings are fully seated.
PARTS LIST FOR FIGURE 1
S13-41805 #1 Drive Shaft Assembly (Splined)
S13-41806 #2 Drive Shaft Assembly (W/Key-way)
QUANTITY ITEM
#1 #2
PART
NUMBER
DESCRIPTION
2 -- 033-70567 #1 (Splined) Drive Shaft 1
-- 1 033-70579 #2 (W/ 5/16 KW) Drive Shaft
2 1 1 230-82140 Shaft bearing MRC-107KS
3 2 2 033-70817 Retaining Ring
4 -- 1 035-71348 Square Key 5/16 x 1 1/4
BARREL AND HOLD-DOWN
1. Position the barrel (1) in a press with the large end turned down and insert tool figure
SHAFT ASSEMBLY T-1 in the splined shaft hole in the barrel.
Figure 2
2. Place thrust washer (3) and spring (4) over shaft (2) in the same sequence as shown.
3. Insert shaft (2) in barrel (1) and rest on tool figure T-1. Position the two spring retainers
(5) around the shaft (2) and inside of spring (4).
4. Carefully place tool figure T-2, with the large end of the tapered hole up, over the shaft
(2) and against the barrel (1) face. Insert ring (6) around the shaft (2) and in the tool.
5. Position the ring with the gap within 5/8” of the notch in the barrel for easy removal.
6. Place tool figure T-3 over the shaft (2) with the small end against ring (6). Press on the
end of the assembly tool and seat the ring (6) in the groove in the barrel (1).
7. Remove the assembly tools. Check to be sure that the ring is properly seated. Check
barrel face to be certain it is not marred.
PARTS LIST FOR FIGURE 2
QUANTITY ITEM
#1 #2
PART
NUMBER
DESCRIPTION
1 -- S13-43657 Barrel & Sleeve Assy. M6 Only 1
-- 1 S13-47511 Barrel & Sleeve Assy. M7 Only
2 1 1 033-70583 Hold-down Shaft
3 1 1 350-10069 Thrust Washer TRA -1220
4 1 1 033-70493 Barrel Hold-down Spring
5 2 2 033-70483 Spring Retainer
6 1 1 033-70494 Retaining Ring
10