DEMAG DRC-DR D2, Руководство по эксплуатации

Страница: 24 / 28

24
21495344.indd/31
1007
Press the F1 key to accept the selected character and to change to the next posi-
tion of the crane identification.
Actuate the F2 key when the crane identification has been entered completely to
transmit the new crane identification to the assigned radio receiver.
It is possible to exit entry mode at any time and to return to display mode:
• DRC-10: Lift keys
• DRC-J: Display keys ↑
Note: Unlike in the other parameter menus, not only entry mode is exited but also
the radio receiver parameter programming menu.
If entry of the crane identification is exited without accepting the entered crane
identification with F2, the crane identification will remain unchanged (entry is
aborted).
When the crane identification has been changed, it may be necessary to log an
older DRC-10 or DRC-J radio transmitter on again for the radio receiver, in order
to transfer the modified crane identification also to the DRC-10 or DRC-J radio
transmitter and to enable this unique assignment of the DRC-10 or DRC-J radio
transmitter to the crane.
The “Logging on the hand-held radio transmitter” steps are described in section 6.2
of the respective operating instructions for the DRC-10 or DRC-J radio transmitter
(see accompanying documents, page 2).
1.8.4 Changing to the next position
1.8.5 Confirming the new crane
identification
1.8.6 Exiting the menu
1.8.7 Repeating the assignment