Does the motor run before inserting
tickets (At power-up)?
YES
Check: Front sensor positioning
leads drive transistor. Power
Supply for
5V to Barcode PCB.
Blocked Entrance block.
Insert a strip of
10-20 tickets.
Does it cut OK?
Power off the TT-2000 and remove the Cutter
Guide assemblies. Clean and then
reposition. Re-test.
Remove cutter, check:
A. Build-up on blade edge
B. Blade is tight on flat of shaft
C. Gear is tight on shaft
D.
Paper in cutter housing
E.
Stationary blade adjustment
F. Proper seating of cutter assy.
Remove Guide Assembly, check:
A. Roller springs must have proper tension
mounting screws tight.
B.
Top guide "finger" should be straight in
line with guide track.
C.
Clear any paper in guide track or
entrance block.
No count at all, try "Relearning"
ticket.
Check options for ticket values ticket style.
Did it count OK?
Miscount? Clean Barcode sensor, blow out any
excess dust. Reposition guide assembly. Check roller
springs for proper shape tension
(see drawings). Re-test. See section above for cutter
guide assemblies
YES
Print OK?
Make sure that the paper is loaded properly.
NOTE: Thermal paper is only printed on one side.
(Check paper loading in manual. pg 7)
