List
TT- 1000
TT-2000
When the guide
is released or entire
is removed
servicing or
proper
Lo
is as
IMPORTANT: The MOTOR
has extra
rings installed
both Lower drive roller and motor shafts. Before replacing
GUIDE
assembly, be sure the rings are not "riding"
the sides of the rollers.
They should be far left or right of Roller ends, towards side plates.
A.
Align both idler roller
with slots
the side plates. At
the same time the
(4)
pins on side of
aligned
with
corresponding slots.
B.
First, place rear Idler roller shaft
it's slots (closest to cutter)
.Second, let front idler roller shaft drop into it's slot
Third, pull
slightly towards you to allow pins to drop
in their slots.
C.
Push
assembly forward until it stops (Toward Cutter)).
assembly is forward, push
DOWN on spring spacer
(has Phillips head screws), to load springs. Rear
should loclc in slots with springs.
See
15
16
details.
D.
Close chute cover. Replace cutter
sure cutter is seated
all the way down to mesh gears.
**See
drawings for details of motor, guide
PAGE
