PCI-DMC-A01/B01 User Guide
Chapter 3 Using EzDMC
3-10
July 2014
Figure 3.13 Open Master Security interface after user login.
The above input fields all have 1~8 bits and accept hexadecimal values between 0~F.
❶
Card ID of DMCNET motion card.
❷
User login and status display field.
❸
Generate verify key.
Step1: Click on the "Read" button to read the product serial number. This gives two sets
of 1 ~ 8 bit values made up of hexadecimal values between 0 ~ F.
Step2: User enters a custom User Key then click on "Make Verify Key" to generate a
verify key. (The input and output will be 1 ~ 8 bits made up hexadecimal values
between 0 ~ F)
Step3: Click on the "Write" button to write the generated Verify Key. (If write is
successful, block
❷
will display "Done". "Failed" is displayed otherwise)
❹
Verify key confirmation field and status display. Enter the 4 sets of Verify Key generated
above into the 4 fields of Check Verify Key then click on "Check Verify Key". (If
verification is successful then "Pass" is displayed on the status bar below". "Lock!" is
displayed otherwise)
➊
➍
➎
➌
➋
➏