5
or
Heating/Cooling
control cycle setting
(Set in PID control mode)
Press
Lower-limit alarm 1
(This parameter is available only when
ALA1 function enables)
Press
Select heating/cooling control
or dual loop output control
Press
Control cycle setting
of 2nd output group
(Set in PID control and Dual Loop
output control mode)
Press
Upper-limit alarm 2
(This parameter is available only when
ALA2 function enables)
Press
Alarm 1 mode setting
Press
P value of 2nd output group =
x
(P value of 1st output group)
P value of 1st & 2nd output group
during dual loop output control
Press
Lower-limit alarm 2
(This parameter is available only when
ALA2 function enables)
Press
Press
Alarm 2 mode setting
Press
Dead Band (Set in Dual Loop
output control mode)
Upper-limit alarm 3
(This parameter is available only when
ALA3 function enables)
Press
Press
Alarm 3 mode setting
Press
Switch setting for feedback
signal of valve. (Display when
valve control is ON)
Lower-limit alarm 3
(This parameter is available only when
ALA3 function enables)
Press
Set system alarm
Press
Press
Automatically regulate
feedback value.
Press
(Display when valve control is ON)
Setting lock mode
Press
Communication write function
enable/disable
Press
Time setting for valve from
full close to full open. (Display when
valve control is ON)
Press
Display and adjust output value
of 1st output group
(Display in PID control mode and manual
RUN mode)
Press
ASCII, RTU communication
format selection
Press
Press
Valve Dead Band setting.
Press
(Display when valve control is ON)
Display and adjust output value
of 2nd output group
(Display in dual loop PID control mode and
manual RUN mode)
Press
Communication address
setting
Press
Upper-limit regulation of
valve output with feedback to
controller. (Display when valve
signal feedback function is ON)
Press
In case of using an external CT,
the controller displays the current
value being measured by CT, if
the control output is ON
Press
to return to set target temperature
Communication baud
rate setting
Press
Lower-limit regulation of
valve output with feedback to
controller. (Display when valve
signal feedback function is ON)
Press
Valve output with feedback.
(Display when valve feedback
function is ON)
Press
Data length setting
Press
Press
Regulate temperature
deviation value
DA value feedback of valve.
(Display when valve feedback
function is ON)
Press
Back to target temperature
Parity bit setting
Press
(The setting display when analog output)
Press
Regulate upper-limit of analog
output value
Stop bit setting
Press to return input type setting
Press
Regulate lower-limit of analog
output value
(The setting display when analog output)
to return to auto-tuning mode
