Delta AH10EN-5A Series, Руководство по эксплуатации

Страница: 47 / 132

C h a p t e r 4 E I P B u il d e r
4 - 2 3
4_
4.4 Data Mapping
When the connection between devices is established, users can use the data mapping function to exchange
data between devices. This section will provide an overview of how to create a data mapping table.
Download
Data Exchange
Data Exchange
Set up
Data Exchange
Table
Network View
Descriptions for the Data Mapping:
1
2 3 4 7 6 8 9 5 10
Name Definition

Connection Count
Data mapping connection count; each row represents one
independent EtherNet/IP connection. The number of connections
cannot exceed the maximum connection number that the Scanner
supports. For the AH10EN-5A series, the maximum connection
number is 64.

Enable Enable / Disable the data mapping function

TAG
Use TAGs created to execute data mapping; after selected, this
function is enabled and

read only (

)

registers are not available for the row selected

the leghth cannot be modified

comsumed TAG should be created in ISPSoft global symbols
beforehand

IP Address
The IP address of the Adapter that you’d like to connect to. After the
data mapping connection is established, the system will load the
connected device’s IP address. Users can also use the drop down list
to select the device’s IP address to add and edit the connection.

Adapter Name
Once the IP address is selected, its name will be displayed but cannot
be modified here. Refer to section 4.3

for more information on
how to change the device name.

CPU Address Start address of the data mapping’s register
Scanner’s register a
address offset (EtherNet/IP
modules) Actual represented register = starting register a address
offset; starting register address can be set on the HWCONFIG setup
page.
If TAG

is selected Consumed TAG can be selected from the drop-down list

Adapter Address/Parameter Target adapter’s register address / parameters
If TAG

is selected
Input the Produced TAG of the EIP to be connected; the default name
is the same as TAG in

.

I/O Mapping Table
Set up the IN/OUT parameters; when there is no I/O representative
table presented for the Adapter, they cannot be opened, for example
some PLCs.