6
A S S E M B LY
INSTRUCTIONS
W ARNING: FOR YOUR OWN SAFETY, DO NOT
CONNECT THE SAW TO THE POWER SOURCE
UNTIL THE SAW IS COMPLETELY A S S E M B L E D
AND YOU HAVE READ AND UNDERSTOOD THE
ENTIRE OWNER S MANUAL.
ASSEMBLING BLADE TILTING
MECHANISM HANDLE
1.
Install fiber washer (A) Fig. 6, on the blade tilting
mechanism shaft (B). Install key (C), into shaft keyway.
2.
Install handwheel (D) onto shaft (B) Fig. 6. Make sure
the groove (E), in the handwheel lines up with the key (C).
3.
Install lock knob (F) Fig. 7, into threaded end of the
shaft (B). Hand-tighten lock knob at this time.
ASSEMBLING EXTENSION WINGS
Assemble the extension wings (A) Fig. 8 and Fig. 10, to
the saw table using the six
5
/
8
″
-24x 1
1
/
4
″
hex head screws
(B) and washers supplied. Use a straight edge (C) Fig. 9,
to make sure the extension wings (A) are level with the
saw table before tightening the screws (B) Fig. 8 and Fig.
10. NOTE: When assembling the left extension wing,
do not install the left front screw and washer at this
time, it will be installed when assembling the on/off
switch.
Fig. 6
A
B
D
C
Fig. 7
F
B
Fig. 8
B
A
Fig. 9
A
C
Fig. 10
B
A
E