11
3.
Fasten the leg bracket (L) Fig. 32, to the end piece (J)
of the table using the two 1
1
/
2
″
flat head Phillips screws, flat
washers and hex nuts (M) Figs. 31 and 32. Fasten the
remaining leg to the extension table in the same manner.
ASSEMBLING EXTENSION TABLE
TO FRONT AND REAR RAILS
1.
Place table assembly (N) Fig. 34, in position between
the two rails, as shown. Make sure end of table (N) is flush
against extension wing (P). Using a straight edge make
sure table (N) is in the same plane and level with saw table
(P). Lightly tap table up or down and adjust leveling screws
(R) Fig. 33, in bottom of legs to accomplish this. When the
table (N) Fig. 34 is level and in the same plane with saw
table (P), drill
1
/
4
″
through holes (S) Fig. 34 through the
front and rear holes in the guide rail closest to the
extension wing. Fasten both front and rear rail to table
using the 1
1
/
2
″
flat head Phillips screws, flat washers, and
hex nuts. Using a level make sure table (N) is in the same
plane and level with saw table (P). Drill
1
/
4
″
through holes
(S) Fig. 34 through the front and rear holes remaining in
the guide rail.
2.
After the holes have been drilled in the edge of the
front and rear extension table board, fasten both front and
rear rail to table using the 1
1
/
2
″
flat head Phillips screws, flat
washers, and hex nuts (M) Fig. 31.
ASSEMBLING GUIDE TUBE
TO FRONT RAIL
Lay the guide tube (B) on the saw table as shown in Fig.
35, and line up the threaded holes on bottom of guide tube
(B) with the through holes (D) on the front rail (A). Fasten
the guide tube to the rail using
1
/
2
″
hex screws and
lockwashers in all of the holes.
REAR SUPPORT TABLE
MOUNTING INSTRUCTIONS
1.
Position the two legs (H) Fig. 36, at the two far corners
of the inside of one end of the extension table, as shown,
and mark the position of the eight holes to be drilled into
the bottom of the table. Remove the two legs (H) and using
a
1
/
16
″
drill bit, drill the eight holes
1
/
2
″
deep. Replace the two
legs and fasten to the bottom of the table using the eight
Fig. 32
J
Fig. 33
Fig. 34
S
P
Fig. 35
D
L
R
M
B
A
N
D
Fig. 36
I
H