16
to lock fence in position. NOTE: A magnet (B) Fig. 56, is
provided to hold clamp handle (A) in the up position when
moving the fence.
3.
The distance the fence is positioned away from the
blade is indicated by the witness line (C) Fig. 57, located
on the cursor (D). If it is necessary to adjust the cursor (D),
make a test cut with the fence locked in position. Measure
the width of the finished cut and adjust the cursor (D) by
loosening the two screws (E), adjusting the cursor (D) until
the witness line (C) is aligned with the same marking on
the scale as the finished cut. Then tighten the two screws
(E).
FENCE LUBRICATION
1.
Apply paste wax to fence, and guide tube, sliding sur-
faces weekly.
2. Apply grease to cam lock (A) and cam foot (B) Fig. 58,
monthly, to prevent wear.
ADJUSTING FENCE PARALLEL
TO MITER GAGE SLOTS
The fence (A) Fig. 59, must be adjusted so it is parallel to
the miter gage slots (B). To check and adjust, move fence
(A) until the bottom edge of the fence is in line with the
edge of one of the miter gage slots as shown in Fig. 59,
and push down on the fence clamping lever (C). Check to
see if the fence (A) is parallel to the miter gage slot, the
entire length of the table. If an adjustment must be made,
l
i
ft up fence locking lever (C) and raise fence up off the
guide tube, as shown in Fig. 60. Slightly tighten or loosen
one of the two adjusting screws (D) or (E) Fig. 60, using a
3
/
16
″
alIen wrench (F), not supplied. Replace the fence on
the guide tube and check again to see if the edge of the
fence is parallel with the miter gage slot the entire length
of the slot. Repeat this adjustment until you are sure the
fence is parallel with the miter gage slot.
IMPORTA N T: VERY LITTLE MOVEMENT OF
Fig. 57
C
E
Fig. 58
Fig. 59
C
Fig. 60
D
F
A
A
B
D
B
E