10
2.
Using template (D) Figures 27 and 28, to check and
adjust front rail at both ends of the saw table as shown, to
make sure rail (A) is parallel with table surface and tighten
rail mounting hardware (B). IMPORTA N T: Template (D)
must be on the saw table when checking, not on
extension wing.
3.
Assemble rear rail (E) Fig. 29, to rear of saw table
using the two
3
/
8
-24 x 1
1
/
4
″
hex head screws (F),
7
/
8
″
O.D.
flat washers, and lockwashers as shown. NOTE: When
mounting, the two screws (F) are threaded into the
threaded holes in the saw table, as shown.
4. Make certain top edge of rail (E) Fig. 29 is below table
surface and that top edge of cut-outs (G) are below miter
gage slots before tightening screws (F).
ASSEMBLING TABLE LEGS
TO EXTENSION TA B L E
1.
Position the two legs (H) Fig. 30, at the two far corners
of the inside of one end of the extension table, as shown,
and mark the position of the eight holes to be drilled into
the bottom of the table. IMPORTA N T: If your saw will be
used with a mobile base underneath the saw base and
table legs, the position of the legs may have to be
changed to fit onto the mobile base. Remove the two
legs (H) and using a
1
/
16
″
drill bit, drill the eight holes
1
/
2
″
deep. Replace the two legs and fasten to the bottom of the
table using the eight
3
/
4
″
wood screws (I) supplied.
2.
Figure 31 illustrates one of the legs (H) fastened to
the bottom of the extension table with the four wood
screws (I). Using a
1
/
4
″
drill bit, drill two through holes
through the end piece (J) of the table, measuring the holes
from the outside frame of the table. The holes are to be
drilled 1
3
/
4
″
from the top (laminate side), and 1
3
/
8
″
and 4
3
/
8
″
from the side.
Fig. 27
B
A
Fig. 28
D
Fig. 29
Fig. 30
I
H
Fig. 31
M
I
A
G
F
E
D
B
J
H