Delta 36-889, Инструкция по эксплуатации

Страница: 8 / 20

8
6. Slide the guide rail along until the “0” on the Unifence
scale is aligned with the right edge of the saw table. Snug
the hex nuts on the saw and extension table but do not
tighten at this time.
7. Adjust the guide rail (C) Fig. 23, parallel with the saw
table surface by placing a square (H) on the saw table at
both the left and right front ends of the table, with the rule
of the square against the flat surface on top of the guide
rail. The guide rail (C) Fig. 23, can be adjusted up or down
at either end. After you are certain the guide rail is parallel
with the table surface, firmly tighten the two hex nuts that
fasten the guide rail to the table.
8. Move the square (H) Fig. 24, to the end of the
Unifence table and check to make certain the same
distance is maintained from the top surface of the
extension table (K) to the top surface of the guide rail (C).
Move the front table support (L) Fig. 25, against the guide
rail (C), and tighten the 1/4-20 nuts (M). Tighten two
wood screws, one of which is shown at (N) Fig. 25, that
fasten the Unifence table to the guide rail.
Fig. 23
Fig. 24
Fig. 25
ASSEMBLING RAIL STOP
1. Insert 1/4-20x2" bolt (A) through hole into one side of
bracket (B) Fig. 26.
2. Place one washer (C), on bolt (A), and slide bolt
through flip stop (D) Fig. 26.
3. Place the other washer (C), on bolt (A), and slide bolt
(A) through other side of bracket (B) Fig. 26.
4. Screw nut (E) onto bolt (A) and tighten.
5. Insert bolt (F) through bracket (B) as shown and
screw knob (G) onto bolt (F) approximately 3 complete
turns. Fig. 26.
6. To attach rail stop to unifence as shown in Fig. 28.
7. Using a rubber mallet (P) Fig. 27, or a hammer and a
block of wood, gently tap end cap (R) into both ends of
the guide rail.
NOTE: To avoid damage to the guide rail,
DO NOT use a metal hammer directly against the guide
rail.
Fig. 26
E
C
F
B
A
G
D
C
H
C
K
H
M
M
L
C
N