Delta 36-889, Инструкция по эксплуатации

Страница: 5 / 20

5
6. Fasten the front (F) and rear table (G) supports Fig.
10, to the bottom of the table as shown using four
#8x7/8" long wood screws (H) supplied. (Pilot holes can
be drilled in the particle using a 1/16" drill bit, drilling
1/2" deep, to help attaching the front and rear table
supports.)
NOTE: At this time, the screws (H) holding the front
support (F) should not be completely tightened.
NOTE: The slots closer to the angles in the supports (F)
and (G) should be against the table.
NOTE: Do not put fasteners in location (I) at this time.
NOTE: Make certain the ends of the table supports do
not extend out past the table. The rear support (G) Fig.
10, can be fastened to the bottom of the table by
tightening screws (H).
CAUTION: DO NOT OVER-TIGHTEN MOUNTING
SCREWS.
Over-tightening screws in particle board may
cause them to strip.
7. Assemble the three brackets (J) to the table adapter
plate (K) using the three 1/4-20x3/4" carriage bolts, nuts and
washers, supplied, as shown in Fig. 11.
NOTE: The long leg
of the brackets (J) should be against the adapter plate (K) as
shown. Do not completely tighten brackets (J) to adapter
plate (K) at this time.
Fig. 10
Fig. 11
F G
H
I
J
K
Fig. 12
Fig. 13
K
L
M
N
J
Fig. 14
A
B
C
FOR DELTA TABLE SAWS ONLY
8. Fasten the table adapter plate (K) to the right side of
the saw table using the three 7/16-20x1" hex head
screws (L) and 7/16" lock washers, supplied, as shown
in Fig. 12.
NOTE: Before tightening screws (L), use a
straight edge (M) to make sure top of the adapter plate
(K) is level with or slightly below surface of the saw table.
Also make sure that the front edge of the adapter (K)
does not stick out past the front edge of the saw table.
FOR TABLE SAWS OTHER THAN DELTA
8. Assemble table adapter plate (K) Fig. 12, to the right
side of the saw table as shown using three 3/4 inch
screws, lockwashers and hex nuts (not supplied).
IMPORTANT: If the pre-drilled holes in adapter plate do
not line up with the holes in the saw table, new holes
must be drilled in adapter plate (K) and/or saw table.
NOTE: Do not drill any hole to fasten adapter plate (K)
Fig. 12, to the saw table that will be located less than
two inches from either end of the adapter plate. Before
tightening three screws (L) Fig. 12, place a straight edge
on the saw table and make certain the top of adapter
plate is level with or slightly below the surface of the saw
table. Also, make certain front of adapter plate (K) Fig.
12, does not extend out past the front edge of the saw
table.
FOR ALL TABLE SAWS
9. Assemble the table (N) to the three brackets (J) Fig.
13, using three #8x7/8" screws (A), (B), and (C), Fig. 14.
NOTE: The two screws (B) and (C), Fig. 14, can be
tightened and screw (A) Fig. 14, should be left slightly
loose at this time.