Delta 36-889, Инструкция по эксплуатации

Страница: 6 / 20

6
Fig. 15
Fig. 16
MOUNTING 52" UNIFENCE
SHELF TO UNISAW WITH
METAL MOTOR COVER
11. Fasten lower shelf bracket (V) Fig. 17, to one end of
lower shelf (W) using two #8x7/8" wood screws supplied
as shown in Fig. 17.
IMPORTANT: The side of the
bracket (V) Fig. 17, with the narrow slots should be
fastened to the table.
12. Fasten bracket (V) Figs. 17 and 18, to saw cabinet as
shown using two 1/4-20 x 5/8" hex head screws, two flat
washers, and hex nuts. Place a flat washer onto a screw
and insert screw through bracket and mounting hole in
saw cabinet, then tighten a hex nut onto bolt, repeat this
same procedure for the other hole.
MOUNTING THE SHELF TO
TABLE LEGS
13. Fasten the other end of lower shelf (W) Fig. 18, to the
lower shelf bracket (X), which was assembled to the two
legs earlier using two #8 x 7/8" wood screws.
Fig. 17
Fig. 18
S
V W
V
W
X
T
T
P
10. Using a straight edge (S) Fig. 15, make certain the
Unifence table surface is level with the saw table by
adjusting two leveling screws located on the bottom of
table legs and adjusting angle brackets (T) Fig. 16, use a
level, side to side and front to back to make sure the
table is level. Then tighten three hex nuts (P).
MOUNTING 52" UNIFENCE
SHELF TO UNISAW WITH
NEW SNAP ON MOTOR
COVER ONLY
NOTE: YOU MUST CUT 5" OFF ONE END OF THE
SHELF FOR THE SHELF (B) FIG. 16A, TO SLIDE INTO
THE NEW MOTOR COVER (C). DISCARD THE SHELF
BRACKET AND SCREWS USED TO ATTACH SHELF
TO SAW CABINET.
Fig. 16A
B
C