Delta 36-889, Инструкция по эксплуатации, Страница: 4 / 20

4
ASSEMBLING TABLE AND
SHELF TO SAW CABINET
1. Remove the right table extension wing and front and
rear guide rails from the saw.
2. Lay the table upside down on the floor or bench, as
shown in Fig. 5.
3. Assemble the two table legs (A) Fig. 6 to the bottom
of the table using eight #8x7/8" wood screws.
IMPORTANT: If your saw will be used with a mobile
base underneath the saw base and table legs, the
position of the legs may have to be changed to fit
onto the mobile base. Assemble the mobile base,
and position legs in mobile base then attach the legs
to the table board.
4. Assemble shelf support bracket (B) Fig. 7, to the
table legs (A) using two U-clamps (C), flat washers, and
hex nuts.
NOTE: Height adjustments to the bracket will
be made later.
Fig. 5
Fig. 6
Fig. 7
5. Insert foot adapter (T) Fig. 8, into the bottom of each
leg (A). Assemble the 3/8" jam nut (V) approximately 3/4
of the way onto leveling screw (W). Thread the leveling
screw (W) into foot adapter. Fig. 9 illustrates the foot
leveling assembly on the table leg. Assemble the
remaining foot assembly to the other table leg in the
same manner.
NOTE: Height adjustments can be made
later.
Fig. 8
Fig. 9
B
A
C