7
PROdUCT SPECIFICATIONS
FUNCTIONAL dESCRIPTION
Model 31-481 DELTA
®
26” Dual Drum Sander is specifically designed to handle both rough and final sanding
processes in a single pass. This machine features an adjustable height automatic feed table and comes with 80-grit
and 120-grit pre-cut sanding belts already installed. This dual drum sander is powered by a 3HP continuous duty
sealed motor with a variable speed feed that enables you work at 3-20 S.F.P.M. The wide feed belt accepts stock as
big as 25 ½” and allows you to sand pieces up to 12 ¼” thick.
UNPACkINg
The machine is heavy, be careful when removing it from the shipping container! Failure to comply
may cause serious injury and/or damage to the sander and/or property!
Your DELTA
®
Dual Drum Sander comes packed in a single container. Use a safety strap to avoid tip over when lifting
machine. Check shipping carton and machine for damage before unpacking.
Open the shipping container. Carefully remove packaging materials, parts and machine from shipping carton.
Always check for and remove protective shipping materials around motors and moving parts. Lay out all parts on a
clean work surface and check that all parts are present and in good condition:
dESCRIPTION (QUANTITY)
Delta 26” Dual Drum Sander (1)
12mm Open End Wrench (1)
Elevation Handle (1)
5mm Hex Wrench (1)
6mm T-Handle Wrench (1)
2mm T-Handle Wrench (1)
Elevation Bracket (1)
dRUM MOTOR SPECIFICATIONS
Type
Induction Ball bearing/
Continuous Duty
Horsepower
3HP
Amps
16A
Voltage
230V
Phase
Single
Hertz
60Hz
RPM
3,450
BELT FEEd MOTOR SPECIFICATIONS
Type
Universal
Horsepower
1/6
PROdUCT SPECIFICATIONS
Maximum sanding width
25-1/2”
Maximum board thickness
12-1/4”
Minimum board thickness
¼”
Minimum board length
6”
Feed Speed
3-20 FPM (variable)
Compare the items to inventory figures; verify that all items are accounted
for before discarding the shipping box. Report any missing or damaged
parts to your distributor or dealer. Prior to tool assembly and use, read
this manual thoroughly to familiarize yourself with proper assembly,
maintenance and safety procedures.
Remove any protective materials and coatings from all of the parts and the
drum sander. The protective coatings can be removed by spraying WD-40
on them and wiping it off with a soft cloth. This may need to be redone
several times before all of the protective coatings are removed completely.
If any parts are missing, do not attempt to plug in the power
cord and turn “ON” the machine. The machine should
only be turned “ON” after all the parts have been obtained and installed
correctly.
Number of Sanding Drums
2
Drum Size
5” x 26”
Drum Speed
1,550 RPM
Dust Ports
2-4”
PROdUCT dIMENSIONS
Footprint
17-3/4” x 43”
Length
31”
Width
46”
Height
53”
Weight
485 lbs.
ShIPPINg dIMENSIONS
Carton Type
Wooden Crate
Length
33”
Width
48”
Height
55”
gross Weight
535 lbs.
