Delta OHM HD33[L]M.GSM, Руководство по эксплуатации

Страница: 8 / 22

HD33[L]M.GSM
- 8 -
V1.10
5 SIM CARD
In order to use the GSM functionalities, a SIM card enabled for data transmission must be
inserted into the data logger. The card should be requested to an operator that has an
adequate coverage of the GSM network in the place where the data logger will be installed. To
insert the card, proceed as follows.
1.
Disconnect the power supply.
2. Unscrew the 4 front screws on the housing and remove the cover.
3. Push the metal block of the SIM tray in the direction of the arrow OPEN, and rotate the tray
upward.
4. Insert the SIM card into its tray so as the SIM card contacts face down and correspond to
the contacts on the electronic board. The SIM has to be inserted between the metal block
and the plastic part.
5. Put the SIM tray back in place and push the metal block in the direction of the arrow LOCK.
6. Close again the housing by fixing the 4 front screws.
Through the HD35AP-S software, set the necessary information for GSM operation: SIM PIN,
name of the APN access point, e-mail account and addresses, FTP address, telephone
numbers, data transmission mode, etc. (see chapter “GSM Options” of the software online
help).
Note: the NORMAL/SERVICE switch located under the SIM card must be in NORMAL position. The
SERVICE position and the PWRKEY button are used to update the GSM module firmware.
The connection symbol (CONN) on the display is ON when the instrument is connected to the
GSM network (the symbol blinks while connecting).
Among the information that you can scroll on display with the button in the lower part of the
data logger, there is also the strength RSSI (Received Signal Strength Indication) in dBm of
the GSM signal received.
SIM holder
block
SIM card