20
Figure 14:
Connecting the TPM to a USB port.
Choose “Start Recording” to automatically launch EMGworks. If
this dialog does not appear, launch “EMGworks Acquisition” from
the Start menu or desktop. As EMGworks is launching, the following
dialog will be displayed:
Figure 15:
Initializing the TPM with EMGworks software.
Please wait a moment while the Trigno Personal Monitor is initial-
ized. The prompt will disappear automatically when the initialization
is complete.
If your system was shipped with sensors, these sensors are already
paired to the Trigno Personal Monitor. Otherwise, it is necessary to
first pair your existing sensors to the Trigno Personal Monitor. Refer
to the section “Pairing Sensors” to perform this process.
Once sensors are paired, create a new configuration in EMGworks
to be loaded onto the TPM. After the desired sensors, settings, and
workflow steps have been configured, select “Synchronize with Tri-
gno Personal Monitor” at the lower-right corner of the Test Configu-
ration Manager. This will load the protocol and associated settings
onto the device.
