19
11.10 Cleaning the milk container
To keep the frother efficient, clean the milk container (D) every
two days as described below:
1. Remove the lid (D2).
2. Remove the milk spout (D5) and intake tube (D4).
3. Turn the froth regulator (D1) to the “INSERT” position (fig.
41) and pull it off upwards.
41
4. Wash all the components thoroughly with hot water and
mild washing-up liquid. All components are dishwasher
safe, placing them in the top basket of the dishwasher.
Make sure there are no milk residues on the hollow and
groove under the dial (fig. 42). If necessary, scrape the
groove with a toothpick.
42
43
5. Rinse inside the froth adjustment dial seat with running
water (fig. 43).
6. Check that the intake tube and spout are not clogged with
milk residues.
7. Replace the dial (in correspondence to the word “INSERT”),
spout and milk intake tube.
8. Place the lid back on the milk container.
11.11 Cleaning the hot water/steam connection
nozzle
Each time you prepare milk, clean the connection nozzle (A8)
with a sponge to remove milk residues from the gaskets (fig.
27).
12. DESCALING
Descale the machine when the message “DESCALE” flashes on
the display (B13).
Important!
• Before use, read the instructions and the labelling on the
descaler pack.
• You should use De’Longhi descaler only. Using unsuitable
descaler and/or performing descaling incorrectly may re-
sult in faults not covered by the manufacturer’s guarantee.
1. Turn the appliance on and wait until it is ready for use;
2. Press the MENU/ESC button (B14) to enter the menu;
3. Press < (B4) or > (B8) (fig. 9) until “Descale” is displayed;
4. Select by pressing the OK button (B12- fig. 10): the mes-
sage “Descale Confirm?” is displayed;
5. Press the OK button again to confirm. “EMPTY DRIP TRAY”
is displayed, alternating with “REMOVE FILTER” (if the filter
is present) and “Add descaler Press OK”;
6. Empty the water tank (A16) completely and remove the
water softener filter (C4), if present. Empty the drip tray
(A12 - fig. 31) and grounds container (A10), then put them
back in the appliance.
B
A
A
B
44
7. Pour the descaler into the
tank up to level
A
(corre-
sponding to a 3,38 fl.oz/
100ml pack) marked on
the inner surface of the
tank (fig. 44), then add
water (33,81 fl.oz/1 litre)
up to level
B
(fig. 44) and
put the water tank back.
45
2 l
8. Place an empty container
with a minimum capacity
of 67,63 fl.oz/2.0 litres
under the coffee spouts
(A7) and hot water spout
(C6) (fig. 45);
Important!
Danger of burns
Hot water containing acid flows
out from the coffee and hot
water spouts. Take care to avoid contact with splashes of this
solution.
9. Press the
OK
button to confirm that you have added the
descaler solution. The message “Descale underway” is dis-
