11
FITTING REQUIREMENTS
■
The oven can be fitted in standard units, width 90 cm and depth 60 cm.
■
Installation requires a compartment as illustrated in figures 5 and 6.
■
On the lower side, the oven must lay on supports standing the oven weight.
■
Remember the housing should not be free standing but be secured to the wall and/or
adjacent fittings.
■
We would point out that the adhesive which bonds the plastic laminate to the
furniture must withstand temperatures not less than 150° C to avoid delamination.
■
The walls of the units must be capable of resisting temperatures of 75 °C above
room temperature.
■
Do not seal the oven into the cabinetry with silicone or glue; this makes future
servicing difficult. Delonghi will not cover the costs of removing the oven, or of
damage caused by this removal.
■
The walls surrounding the oven must be made of heat-resistant material.
■
WARNING: Taking care NOT to lift the oven by the door handle.
WARNING
When correctly installed, your product meets all safety requirements laid down for
this type of product category.
However special care should be taken around the rear or the underneath of the
appliance as these areas are not designed or intended to be touched and may
contain sharp or rough edges, that may cause injury.
IMPORTANT
Some environmental factors and cooking habits can cause condensation in and
around the oven during use. To protect surrounding cabinetry from possible damage
caused by frequent or excessive condensation, we recommend moisture-proofing
the oven cavity.
Содержание DEP909P
Страница 2: ...2 ...