1.
Follow the procedures in
Before You Begin
.
2.
Remove the computer cover (see
Removing the Computer Cover
).
3.
If present, press the tab on the card retention device that lays over the installed cards and rotate it upwards to gain full access to the card.
4.
Gently securing both graphics cards with one hand, remove the graphics card bridge (if present) with your other hand by pulling it up and away from the
computer. Set it aside.
5.
Disconnect any cables connected to the card.
6.
Press down the tab on the top of the card retainer at the appropriate card slot and pivot the card retainer back through the chassis wall.
7.
Press the release tab (if present) on the system board connector as you grasp the card by its top corners, and then ease the card out of the connector.
1 graphics card bridge
2 power connectors (2)
3 dual-PCI Express graphics cards
1
release tab
2
card retainer
3
alignment guide
4
fan bracket
NOTE:
If the card is full length, press the release tab on the end of the alignment guides on the fan bracket.
