Dell PowerVault TL1000, Руководство пользователя

Страница: 157 / 192

Table 31. Ultrium Tape drive sense data - Bytes 12 and 13 (continued)
Byte 12 ASC Byte 13 ASCQ Description
04 02 Initializing Command Required - A cartridge is present in the drive, but is not
logically loaded. A Load command is required.
04 03 Manual Intervention Required - A cartridge is present in the drive but could not be
loaded or unloaded without manual intervention.
0C 00 Write Error - A Write operation has failed. This is probably due to bad media, but
may be hardware related.
11 00 Unrecovered Read Error - A Read operation failed. This is probably due to bad
media, but may be hardware related.
11 12 Auxiliary memory read error. The drive reported that it is unable to read the
Auxiliary Memory in a WORM cartridge.
14 00 Recorded Entity Not Found - A space or Locate command failed because a format
violation prevented the target from being found.
14 03 End Of Data not found - A Read type operation failed because a format violation
related to a missing EOD data set.
14 10 Not Ready - Auxiliary memory not accessible. The drive is not able to become
ready because it is unable to access the Auxiliary Memory in a WORM cartridge.
1A 00 Parameter list length error - The amount of parameter data sent is incorrect.
20 00 Invalid Command Operation Code - The Operation Code in the command was not
a valid Operation Code.
24 00 Invalid field in CDB - An invalid field has been detected in a Command Descriptor
Block.
25 00 LUN not supported - The command was addressed to a non-existent logical unit
number.
26 00 Invalid Field in Parameter List - An invalid field has been detected in the data sent
during the data phase.
27 00 Write Protect - A Write type operation has been requested on a cartridge which has
been write protected.
28 00 Not Ready to Ready Transition - A cartridge has been loaded successfully into the
drive and is now ready to be accessed.
29 00 Reset - The drive has powered on, received a reset signal or a bus device reset
signal since the initiator last accessed it.
2A 01 Mode Parameters Changed - The Mode parameters for the drive have been
changed by an initiator other than the one issuing the command.
30 00 Incompatible Media Installed - A write type operation could not be executed
because it is not supported on the cartridge type that is loaded.
30 01 Unknown Format - An operation could not be carried out because the cartridge in
the drive is of a format not supported by the drive.
30 02 Incompatible Format - An operation could not be completed because the Logical
Format is not correct.
30 03 Cleaning Cartridge Installed - An operation could not be carried out because the
cartridge in the drive is a cleaning cartridge.
30 07 Cleaning Failure - A cleaning operation was attempted, but could not be completed
for some reason.
30 0C Data Protect - WORM overwrite attempted. The drive rejected a write operation
because it would have resulted in an overwrite. Overwrite is not allowed on
WORM media.
Appendix C. Sense data
139