Dell PowerEdge systems 6300, Руководство пользователя

Страница: 54 / 143

3-22 Dell PowerEdge 6300 Systems User’s Guide
To install the IntranetWare Support Pack 4.0A complete these steps:
3ODFHWKH6XSSRUW3DFNILOHRQWRDZRUNVWDWLRQWKDWLVDWWDFKHGWRWKH
3RZHU(GJHVHUYHU
&RS\WKHVXSSRUWSDFNILOHWRDYROXPHRQWKHVHUYHU
([SDQGWKHILOHE\W\SLQJ
iwsp4a.exe
DQGSUHVV(QWHU!
)ROORZWKHGLUHFWLRQVOLVWHGLQWKH LZVSDW[W ILOHLQFOXGHGZLWKWKH
VXSSRUWSDFN
When Support Pack 4.0A has been applied, you can install SMP on your system.
,QVWDOOLQJ6036XSSRUW
To add SMP support to your NetWare 4.11 installation, use the following procedure:
$WWKH1HW:DUHFRQVROHSURPSWW\SH
Load install
DQGSUHVV
(QWHU!
)URPWKHLQVWDOODWLRQVFUHHQWKDWDSSHDUVVHOHFW0XOWL&382SWLRQV
DQGSUHVV(QWHU!
)URPWKHVHOHFWLRQVFUHHQVHOHFW6HOHFWD3ODWIRUP0RGXOHDQGSUHVV
(QWHU!
)URPWKHQH[WVHOHFWLRQVFUHHQVHOHFW036360DQGSUHVV(QWHU!
A confirmation screen appears asking if you want to load the selected module.
6HOHFW<HVDQGSUHVV(QWHU!
A message screen appears.
([LWWKHPHVVDJHVFUHHQVZLWFKWRWKHFRQVROHSURPSWGRZQWKHVHUYHU
DQGUHERRWWKHV\VWHPWRHQDEOH603VXSSRUW
8VLQJ VWDUWXSQFI DQG DXWRH[HFQFI
The startup.ncf and autoexec.ncf files contain a set of commands that are executed
during the boot routine. The startup.ncf file contains commands to load the disk driv-
ers. Once startup.ncf loads disk drivers, control is passed to the autoexec.ncf file to
complete the boot routine. For additional information on the startup.ncf and
autoexec.ncf files, refer to your NetWare documentation.
To automatically load the aic78u2.ham driver during the boot routine, the startup.ncf
file must contain a load command line that specifies the location of the driver on the
hard-disk drive. To find the slot number, type
load a:\scsi\aic78u2.ham
at the
console prompt and press <Enter>. A list of slot numbers is displayed separated by
commas. Press <Esc> to clear the command line.