Dell PowerEdge systems 6300, Руководство пользователя

Страница: 70 / 143

4-10 Dell PowerEdge 6300 Systems User’s Guide
which is included with your software support utilities, to enter an asset tag num-
ber up to ten characters long into NVRAM. See “Asset Tag Utility” in Chapter 2
for information on loading the Asset Tag utility.
8VLQJWKH6\VWHP3DVVZRUG)HDWXUH
&$87,217KHSDVVZRUGIHDWXUHVSURYLGHDEDVLFOHYHORIVHFXULW\IRUWKH
GDWDRQ\RXUV\VWHP+RZHYHUWKH\DUHQRWIRROSURRI,I\RXUGDWDUHTXLUHV
PRUHVHFXULW\LWLV\RXUUHVSRQVLELOLW\WRREWDLQDQGXVHDGGLWLRQDOIRUPVRI
SURWHFWLRQVXFKDVGDWDHQFU\SWLRQSURJUDPV
Your Dell system is shipped to you without the system password feature enabled. If
system security is a concern, you should operate your system only with system
password protection.
You can assign a system password, as described in the next subsection, “Assigning a
System Password,” whenever you use the System Setup program. After a system
password is assigned, only those who know the password have full use of the
system.
When System Password is set to Enabled, the computer system prompts you for the
system password just after the system boots.
To change an existing system password, you must know the password (see “Deleting
or Changing an Existing System Password” found later in this section). If you assign
and later
forget a system password, you need to be able to remove the computer
cover to change a jumper setting that disables the system password feature (see
“Disabling a Forgotten Password” found later in this chapter). Note that when
you erase the system password, you erase the setup password at the same time.
&$87,21,I\RXOHDYH\RXUV\VWHPUXQQLQJDQGXQDWWHQGHGZLWKRXWKDYLQJ
DV\VWHPSDVVZRUGDVVLJQHGRULI\RXOHDYH\RXUFRPSXWHUXQORFNHGVR
WKDWVRPHRQHFDQGLVDEOHWKHSDVVZRUGE\FKDQJLQJDMXPSHUVHWWLQJDQ\
RQHFDQDFFHVVWKHGDWDVWRUHGRQ\RXUKDUGGLVNGULYH
$VVLJQLQJD6\VWHP3DVVZRUG
Before you can assign a system password, you must enter the System Setup program
and check System Password.
When a system password is assigned, System Password is Enabled. When the sys-
tem password feature is disabled by a jumper setting on the system board, the status
shown is Disabled by Jumper.
You cannot change or enter a new system password
if either of these options is displayed .
When no system password is assigned and the password jumper on the system
board is in the enabled position (its default), the status shown for System Password is
Not Enabled.
Only when System Password is set to Not Enabled can you assign a sys-
tem password, using the following procedure:
9HULI\WKDW3DVVZRUG6WDWXVLVVHWWR8QORFNHG