Dell PowerEdge R510, Руководство владельца оборудования

Страница: 122 / 216

122
Installing System Components
5
Press down and out on the ejectors on each end of the socket until the
memory module pops out of the socket. See Figure 3-19.
Handle each memory module only on either card edge, making sure not to
touch the middle of the memory module.
6
Replace the cooling shroud. See "Installing the Cooling Shroud" on
page 91.
7
Close the system. See "Closing the System" on page 89.
8
Reconnect the system and peripherals to their power sources, and turn
them on.
Expansion Cards and Expansion-Card Risers
Your system supports up to four PCI Express (PCIe) expansion cards installed
in connectors on an expansion-card riser.
Depending on the configuration, your system may have either riser 1 or
riser 2:
• Expansion-card riser 1 provides three x4 Gen2 PCIe expansion-card slots
and one x8 Gen2 PCIe expansion-card slot.
• Expansion-card riser 2 provides one x4 Gen2 PCIe expansion-card slot and
one x16 Gen2 PCIe expansion-card slot.
CAUTION:
Expansion cards can only be installed in the slots on the
expansion-card riser. Do not attempt to install expansion cards directly into
the riser connector on the system board.
Expansion Card Installation Guidelines
• The expansion-card slots support full-height, half-length cards.
• The expansion-card slots are hot-swappable.
• PCI Express Generation 2 expansion cards are supported in all the slots.
book.book Page 122 Friday, November 20, 2009 2:56 PM