Dell POWEREDGE 4300, Инструкция по установке и устранению неисправностей

Страница: 62 / 217

5-8 Dell PowerEdge 4300 Systems Installation and Troubleshooting Guide
1XPEHURI7LPHVWR5HSHDW7HVWV
This parameter specifies the number of times the tests run when you select Run. To
change the default, type the desired value. If you type
(zero), the tests will run
indefinitely.
0D[LPXP(UURUV$OORZHG
This parameter specifies the maximum number of errors that can occur before testing
is stopped. The error count begins from zero each time you run a subtest or test
group individually or each time you select
All to run all of them. To change the default,
type the desired value. If you type (zero), you are specifying that there be no limit on
the number of errors that can occur—testing will not be stopped, regardless of the
number of errors.
3DXVHIRU8VHU5HVSRQVH
If this parameter value is set to Yes, the diagnostics pauses when one of the following
occurs:
‡
Your interaction is needed to verify the Video test group screens or the Key-
board test group key functions, or another type of interaction, such as inserting a
diskette, is required.
‡
The maximum error limit is reached.
If Pause for User Response is set to No , the diagnostics ignores some subtests that
require your interaction; certain subtests can run only if this option is set to Yes
7DEOH2SWLRQV3DUDPHWHUV
3DUDPHWHU 3RVVLEOH9DOXHV
Number of
Times to Repeat
Test(s) 0001 through 9999 , or 0000 , which loops indefinitely until
you press <Ctrl><Break>. The default is 1 .
Maximum Errors
Allowed 0000 through 9999 , where 0000 means that there is no error
limit. The default is 1 .
Pause for User
Response Yes , No
Allows you to decide whether tests will wait for user input.
The default is
Yes to wait for user input.
Output Device
for Status
Messages Display , Printer , File
If you have a printer attached to the computer, you can use it
to print the status messages, if any, that are generated when
a test runs. (The printer must be turned on and in the online
mode to print.) If you select
File , the messages are printed to
a file named result on a diskette in drive A. The default is
Display .
Output Device
for Error
Messages Display , Printer , File
This parameter has the same effect as the Output Device
for Status Messages parameter, except that it pertains only
to error messages. The default is Display .