Dell POWEREDGE 4300, Инструкция по установке и устранению неисправностей

Страница: 135 / 217

Installing System Board Options 8-11
8. Run the RCU. Then save the configuration and exit the utility.
Running the RCU and saving the configuration is required for the system to
recognize the newly installed DIMMs. See Chapter 5, “Using the Resource Con-
figuration Utility,” in the
User’s Guide for instructions on running the utility and
saving the configuration.
9. Run the RAM test group in the Dell Diagnostics.
See Chapter 5, “Running the Dell Diagnostics,” for information.
,QVWDOOLQJ',00V
To install a DIMM, follow these steps:
1. Press the ejectors on the DIMM socket down and outward, as shown in Fig-
ure 8-6, to allow the DIMM to be inserted in the socket.
)LJXUH,QVWDOOLQJD',00
2. Align the DIMM’s edge connector with the slot in the center of the DIMM socket,
and insert the DIMM in the socket.
The card-edge connector on the DIMM has two notches that allow the DIMM to
be installed in the socket in only one way (see Figure 8-6).
3. Press down on the DIMM with your thumbs while pulling up on the ejectors with
your index fingers to lock the DIMM into the socket (see Figure 8-6).
When the DIMM is properly seated in the socket, the ejectors on the DIMM
socket should align with the ejectors on the other sockets with DIMMs installed.
4. Continue with step 7 of “Performing a Memory Upgrade” found earlier in this
section.
notches (2)
1.
2.
ejectors (2)
3.