Dell PowerEdge 2450, Инструкция по установке и устранению неисправностей

Страница: 19 / 166

support.dell.com Messages and Codes 3-3
(#)*
Improperly connected or missing
CD-ROM drive. Check that the diskette drive/
CD-ROM drive unit is seated
properly against the interposer
board on the peripheral cage. See
Chapter 9, “Installing a Drive in
the Peripheral Bay.” Replace the
drive. See Chapter 11, “Getting
Help,” for instructions on obtain-
ing technical assistance.
(+",!
!
Two different types of micropro-
cessors are installed Install a correct version of the
microprocessor so both micro-
processors have the same level 2
cache size.
#
Faulty diskette, diskette drive, or
hard-disk drive Replace the diskette, diskette
drive, or hard-disk drive.
#
One or more DIMMs improperly
seated or faulty Remove and reseat the DIMMs.
If the problem persists, replace
the DIMMs. See Chapter 11,
“Getting Help,” for instructions
on obtaining technical assistance.
# -
# .
Faulty or improperly inserted dis-
kette, incorrect configuration
settings in System Setup pro-
gram, loose diskette/tape drive
interface cable, or loose power
cable Replace the diskette. Run the
System Setup program to correct
the diskette drive type. See
Chapter 4, “Using the System
Setup Program,” in the
User's
Guide for instructions. Check that
the diskette drive/CD-ROM drive
unit is seated properly against the
interposer board on the peripheral
cage. See Chapter 9, “Installing a
Drive in the Peripheral Bay.”
#
Faulty diskette, faulty or improp-
erly connected diskette/tape
drive, or loose power cable Check that the diskette drive/
CD-ROM drive unit is seated
properly against the interposer
board on the peripheral cage. See
Chapter 9, “Installing a Drive in
the Peripheral Bay.”
#
Faulty diskette/tape drive control-
ler (defective system board) Replace the system board. See
Chapter 11, “Getting Help,” for
instructions on obtaining technical
assistance.
NOTE: For the full name of an abbreviation or acronym used in this table, see “Abbreviations and Acronyms."