Dell PowerEdge 1800, Инструкция по установке и устранению неисправностей, Страница: 27 / 160

Indicators, Codes, and Messages
27
Processor n internal error
Faulty microprocessor; faulty system
board. See "Troubleshooting the
Microprocessors" in "Troubleshooting
Your System."
Processor bus parity error
Processor in socket 1 not
installed!
No microprocessor installed in
primary microprocessor socket. Install a microprocessor in the primary
microprocessor socket. See "Processors"
in "Installing System Options."
Remote access controller
error
Embedded remote access memory
may be temporarily corrupted. This message is not applicable to this
system.
Remote access controller
is not present
SCSI cable not present on
connector A or B of the
primary backplane
SCSI cable is loose, improperly
connected, or faulty. This message is not applicable to this
system.
Shutdown failure
Shutdown test failure. See "Troubleshooting System Memory"
in "Troubleshooting Your System."
Spare bank enabled
Memory spare bank enabled This message is not applicable to this
system.
System backplane error
Faulty or improperly installed SCSI
backplane board. This message is not applicable to this
system.
System halted! Must power
down
Wrong password entered too many
times. Information only.
The amount of system
memory has changed
Memory has been added or removed
or a memory module may be faulty. If memory has been added or removed,
this message is informative and can be
ignored. If memory has not been added
or removed, check the SEL to determine
if single-bit or multi-bit errors were
detected and replace the faulty memory
module. See "Troubleshooting System
Memory" in "Troubleshooting Your
System."
Time-of-day clock stopped
Faulty battery. See "Troubleshooting the System
Battery" in "Troubleshooting Your
System."
Time-of-day not set -
please run SETUP program
Incorrect Time or Date settings; faulty
system battery. Check the Time and Date settings. See
"Using the System Setup Program" in
the
User's Guide . If the problem persists,
replace the system battery. See
"Replacing the System Battery" in
"Installing System Options."
Table 2-8. System Messages (continued)
Message Causes Corrective Actions