Dell PowerConnect W-7200 Series, Справочное руководство

Страница: 815 / 1538

Column Description
status Shows if the interface is currently enabled or disabled.
pkts Number of packets seen on the AP’s wired interface.
macs Number of MAC addresses in the Wired MAC table for that interface.
gw-macs Number of MAC addresses in the Wired MAC table for that interface.
tagged-pkts Number VLAN-tagged packets sent to that interface.
vlan The VLAN ID for the packets sent to that interface.
Packets read Number of packets read by the AP since it was last reset.
Bytes read Number of bytes read by the AP since it was last reset.
Num Intercepts Number of interrupts from the AP’s driver.
Num Buffer Overflows Number of times excessive traffic has filled the AP’s buffers.
Max PPS Maximum throughput rate seen on the interface, in packets per second.
Cur PPS Current throughput rate seen on the interface, in packets per second.
Max PPI Maximum interrupt rate seen on the interface, in interrupts per second.
Cur PPI Current interrupt rate seen on the interface, in interrupts per second.
Uptime Number of seconds since the AP was last reset.
LMS IP IP address of the AP’s local controller.
Master IP IP address of the AP’s master controller.
AP type AP model type.
Country Code The AP’s country code. Valid radio channels for your wireless network are based on your
country code. If you change the AP’s country code, the valid channels will be reset to the
defaults for the new country.
ap Number of other APs monitored by this AP.
sta Number of clients and APs seen by this AP.
pap Number of potential APs; APs which have transmitted a beacon, but have not yet been
registered.
psta Number of potential stations; AP has seen a MAC address from the station but hasn’t yet
received traffic from it.
ch Number of channel entries in the channel table.
msg-hash Number of different message types seen on the interface.
ap-l (For internal use only)
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap monitor debug | 815