Dell PowerConnect W-7200 Series, Справочное руководство

Страница: 807 / 1538

Parameter Description
ap-name Name of Access Point
bssid
BSSID of Access Point
ip-addr
IP Address of Access Point
mesh-list
Show list of Mesh APs being monitored.
pot-ap-list Display the Potential AP table. The Potential AP table shows the following data:
l
bssid: the AP’s Basic Service Set Identifier.
l
channel: The AP’s current radio channel
l
phy type: The radio’s PHY type. Possible values are 802.11a, 802.11a-HT-40, 802.11b/g,
802.11b/g-HT-20.
l
num-beacons: Number of beacons seen during a 10-second scan
l
tot-beacons: Total number of beacons seen since the last reset.
l
num-frames: Total number of frames seen since the last rest.
l
mt: Monitor time; the number of timer ticks elapsed since the controller first
recognized the AP.
l
at: Active time, in timer ticks.
l
ibss: Shows if ad-hoc BSS is enabled or disabled. It will be enabled if the bssid has
detected an ad-hoc BSS (an ibss bit in an 802.11 frame).
l
rssi: The Receive Signal Strength Indicator (RSSI) value displayed in the output of this
command represents signal strength as a signal to noise ratio. For example, a value of
30 would indicate that the power of the received signal is 30 dBm above the signal
noise threshold.
pot-client-list Display the Potential client table. The Potential Client table shows the following values:
l
last-bssid: the Last BSSID to which the client associated.
l
from-bssid,
l
to-bssid
l
mt:Monitor time; the number of timer ticks elapsed since the controller first
recognized the client.
l
it: Client Idle time, expressed as a number of timer ticks.
routers
Show Router MAC Addresses learned. The output of this command includes the router’s
MAC address, IP address and uptime.
wired-mac
Show Wired MAC Addresses learned.
ap-name <ap-name> Show data for an AP with a specific name.
bssid <bssid>
Show data for a specific Basic Service Set Identifier (BSSID) on an AP. The Basic Service
Set Identifier (BSSID) is usually the AP’s MAC address.
ip-addr <ip-addr>
Show data for an AP with a specific IP address by entering its IP address in dotted-
decimal format.
ap-bssid <ap-
bssid>
Include the optional ap-bssid <ap-bssid> parameters to show how the AP is monitoring
information for another AP with a specific BSSID.
enet-mac <enet-
mac>
Include the optional enet-mac <enet-mac> parameters to show how the AP is monitoring
information for an interface with a specific Ethernet MAC address.
Examples
The output of the command displays the Monitored AP table, which lists all the APs monitored by a specified AP or
BSSID.
(host) #show ap monitor ap-list ap-name al12
Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide show ap monitor | 807