Dell PowerConnect W-7200 Series, Справочное руководство

Страница: 700 / 1538

700 | show ap config Dell PowerConnect W-Series ArubaOS 6.2 | Reference Guide
Parameter Description
than necessary. This helps avoid higher levels of
interference on the WLAN. Although this setting is disabled
by default, you may want to enable this feature if your APs
are deployed in close proximity (e.g. less than 60 feet apart).
Scan mode Identifies the scan mode for the AP.
l
all-reg-domain: The AP scans channels within all
regulatory domains. This is the default setting.
l
reg-domain:Limit the AP scans to just the regulatory
domain for that AP.
40 MHz intolerance The specified setting allows ARM to determine if 40 MHz
mode of operation is allowed on the 5 GHz or 2.4 GHz
frequency band only, on both frequency bands, or on
neither frequency band.
Honor 40 MHz intolerance Shows if 40 MHz intolerance is enabled or disabled. If
enabled, the radio will stop using the 40 MHz channels if
the 40 MHz intolerance indication is received from another
AP or station.
Legacy station workaround Shows if interoperability for misbehaving legacy stations is
enabled or disabled.
SSID enable
Shows if the SSID is enabled or disabled
ESSID
Name that uniquely identifies the Extended Service Set
Identifier (SSID).
Encryption
Encryption type used on this AP.
DTIM Interval
Shows the interval, in milliseconds, between the sending of
Delivery Traffic Indication Messages (DTIMs) in the beacon.
This is the maximum number of beacon cycles before
unacknowledged network broadcasts are flushed.
Basic Rates
Lists supported 802.11a rates, in Mbps, that are advertised in
beacon frames and probe responses from this AP.
Transmit Rates Lists 802.11a rates at which the AP is allowed to send data.
The actual transmit rate depends on what the client is able
to handle, based on information sent at the time of
association and on the current error/loss rate of the client.
Station Ageout Time Time, in seconds, that a client is allowed to remain idle
before being aged out.
Max Transmit Attempts
Maximum number of retries allowed for the AP to send a
frame
RTS Threshold Wireless clients transmitting frames larger than this
threshold must issue Request to Send (RTS) and wait for the
AP to respond with Clear to Send (CTS). This helps prevent
mid-air collisions for wireless clients that are not within
wireless peer range and cannot detect when other wireless
clients are transmitting.