Display panel
Removing the display panel
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
6. Remove the
The following image indicates the location of display panel and provides a visual representation of the removal procedure.
1. Using a plastic scribe, slide out the pull tab of the SR tape from both sides of the display panel.
2. Pull out a small section of the SR tape.
3. Roll the SR tape around the plastic scribe.
NOTE:
To avoid severing/breaking the SR tape, pull out only a small section of the SR tape and then roll the SR tape
around the scribe.
4. Lift the display panel off the display back-cover.
5. Peel the tape that secures the display cable to the display back-cover.
6. Open the latch and disconnect the display cable from the display back-cover.
Installing the display panel
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display panel and provides a visual representation of the installation procedure.
1. Peel off the transparent protective films from the SR tapes.
2. Align and adhere both the SR tapes to the plastic edge of the display back-cover.
3. Peel off the blue protective films from the SR tapes.
4. Starting from the top, align and place the display panel on the display back-cover.
5. Remove the release paper from the pressure film.
6. Adhere the pressure film on the display panel.
7. Using the flat end of the plastic scribe or handle of the screwdriver, press and roll over the pressure films until they turn
pink.
8. Peel off the pressure film from the display panel.
9. Place the display bezel on the display back-cover and snap it into place.
1. Install the
2. Install the
.
3. Install the
.
4. Install the
.
5. Install the
.
After working inside your computer
.
Display hinges
Removing the display hinges
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
Removing and installing components
33
