Installing the power-adapter port
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of power-adapter port and provides a visual representation of the installation
procedure.
1. Connect the power-adapter port cable to the system board.
2. Replace the screw (M2x3) that secures the power-adapter port to the palm-rest and keyboard assembly.
1. Install the
.
2. Install the
.
After working inside your computer
.
Display assembly
Removing the display assembly
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
The following image indicates the location of display assembly and provides a visual representation of the removal procedure.
Remove the palm-rest and keyboard assembly off the display assembly.
Installing the display assembly
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display assembly and provides a visual representation of the installation procedure.
1. Align and place the palm-rest and keyboard assembly on the display assembly.
2. Using the alignment posts, close the display hinges.
1. Install the
.
2. Install the
.
After working inside your computer
.
I/O board
Removing the I/O board
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
The following image indicates the location of I/O board and provides a visual representation of the removal procedure.
1. Open the display hinges at an angle of 90 degrees.
2. Peel the tape that secures the I/O-board cable to the I/O board.
3. Open the latch and disconnect the I/O-board cable from the I/O board.
4. Remove the screw (M2.5x2.5) that secures the I/O board to the palm-rest and keyboard assembly.
5. Remove the screw (M2x3) that secures the I/O board to the palm-rest and keyboard assembly.
6. Lift the I/O board off the palm-rest and keyboard assembly.
28
Removing and installing components
