2. Replace the screw (M2x4) that secures the system board to palm-rest and keyboard assembly.
3. Connect the display cable on to the connector on the system board6
4. Connect the power-adapter port cable to the system board.
5. Connect the coin-cell battery cable to the system board.
6. Connect the keyboard backlit cable to the system board and close the latch to secure the cable.
7. Connect the keyboard cable to the system board and close the latch to secure the cable.
8. Connect the touchpad cable to the system board and close the latch to secure the cable.
9. Connect the fingerprint-reader cable to the system board and close the latch to secure the cable.
10. Connect the speaker cable to the system board.
11. Connect the I/O-board cable to the system board and close the latch to secure the cable.
12. Adhere the tape that secures the I/O-board cable to the system board.
1. Install the
.
2. Install the
.
3. Install the
.
4. Install the
.
5. Install the
.
6. Install the
or
, whichever applicable.
7. Install the
.
8. Install the
.
After working inside your computer
.
Display bezel
Removing the display bezel
Before working inside your computer
.
2. Remove the
.
3. Remove the
.
4. Remove the
.
5. Remove the
.
The following image indicates the location of display bezel and provides a visual representation of the removal procedure.
1. Carefully pry the edges of the display bezel off the .
2. Remove the display bezel off the .
Installing the display bezel
If you are replacing a component, remove the existing component before performing the installation procedure.
The following image indicates the location of display bezel and provides a visual representation of the installation procedure.
Align the display bezel with the , and gently snap the display bezel into place.
1. Install the
.
2. Install the
.
3. Install the
.
4. Install the
.
After working inside your computer
.
32
Removing and installing components
