Dell Olympus O-T600, Инструкция по установке и обслуживанию

Страница: 118 / 136

3. To install a new system battery, hold the battery with the positive side facing up and slide it under the securing tabs.
4. Press the battery into the connector until it snaps into place.
Figure 111. Installing the system battery
Next steps
1. If removed, connect the cables to the expansion card(s).
2. Follow the procedure listed in
After working inside your system on page 28.
3. While booting, press F2 to enter the System Setup and ensure that the battery is operating properly.
4. Enter the correct time and date in the System Setup
Time and Date fields.
5. Exit the System Setup.
Optional internal USB memory key
Replacing the optional internal USB memory key
Prerequisites
CAUTION: To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in Safety instructions on page 27.
2. Follow the procedure listed in Before working inside your system on page 28.
Steps
1. Locate the USB port or USB memory key on the system board.
To locate the USB port, see the System board jumpers and connectors .
2. If installed, remove the USB memory key from the USB port.
3. Insert the replacement USB memory key into the USB port.
Next steps
1. Follow the procedure listed in After working inside your system on page 28.
2. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.
Control panel assembly
Removing the control panel assembly
Prerequisites
1. Follow the safety guidelines listed in Safety instructions on page 27.
2. Follow the procedure listed in Before working inside your system on page 28.
3. Remove the cooling fan assembly .
Installing and removing system components 117