Dell Networking 2048, Справочное руководство

Страница: 589 / 1823

Port Channel Commands
589
30
Port Channel Commands
Dell Networking N2000/N3000/N4000 Series Switches
A port channel is a set of one or more links that can be aggregated together to
form a bonded channel (Link Aggregation Group or LAG or port channel).
Individual conversations in a particular direction always travel over a single
link in the port channel, however, in aggregate, the bandwidth usage of all of
the links is fairly evenly distributed. Port channels have the advantage of
allowing incremental bandwidth to be added as needed (by adding additional
links) and supporting a form of fault tolerance (traffic on failed links is
redistributed among other links in the LAG). LAGs are formed from similarly
configured physical links, i.e. the speed, duplex, auto-negotiation, PFC
configuration, DCBX configuration, etc. must be identical on all member
links.
Care must be taken while enabling this type of configuration. If the Partner
System is not 802.3AD compliant or the Link Aggregation Control protocol is
not enabled, there may be network instability. Network instability occurs
when one side assumes that the members in an aggregation are one single
link, while the other side is oblivious to this aggregation and continues to
treat the 'members' as individual links.
In the Dell Networking system, the Actor System waits for 3 seconds before
aggregating manually. The 3 second wait time is specified by the protocol
standard.
If a manual LAG member sees an LACPDU that contains information
different from the currently configured default partner values, that particular
member drops out of the LAG. This configured member does not aggregate
with the LAG until all the other active members see the new information.
When each of the other active members sees the new information, they
continue to drop out of the LAG. When all the members have dropped out of
the LAG, they form an aggregate with the new information.
2CSNXXX_SWUM200.book Page 589 Tuesday, December 10, 2013 1:22 PM