Dell Networking 2048, Справочное руководство

Страница: 1627 / 1823

SNMP Commands
1627
Command Mode
Global Configuration Mode
User Guidelines
View-name should be an existing view created using the snmp-server view
command. If there are multiple records with the same view-name, then the
argument specified in this command points to first view-name in the table.
Example
The following example attaches a group called user-group to SNMPv3 and
assigns to the group the privacy security level and read access rights to a view
called
user-view
.
console(config)# snmp-server group user-group v3 priv read user-view
snmp-server host
Use the snmp-server host command in Global Configuration mode to specify
the recipient of Simple Network Management Protocol notifications. To
remove the specified host, use the no form of this command. This command
enters the user into SNMP-host configuration mode.
Syntax
snmp-server host
host-addr
[ informs [ timeout
seconds
] [ retries
retries
] |
traps version { 1 | 2 }]] community-string [ udp-port
port
] [ filter
filtername
]
no snmp-server host
host-addr
{ traps | informs }
•
host-addr
—Specifies the IP address of the host (targeted recipient) or the
name of the host. (Range:1-158 characters)
• community-string —Specifies a password-like community string sent with
the notification operation. (Range: 1-20 characters)
• traps —Indicates that SNMP traps are sent to this host.
• version 1 —Indicates that SNMPv1 traps will be used.
• version 2 —Indicates that SNMPv2 traps will be used.
• informs — Indicates that SNMPv2 informs are sent to this host.
2CSNXXX_SWUM200.book Page 1627 Tuesday, December 10, 2013 1:22 PM