Dell Networking 2048, Справочное руководство

Страница: 540 / 1823

540
iSCSI Optimization Commands
AE Selector = 1
AE Protocol = 3260
AE Priority = priority configured for iSCSI PFC (the VPT value above). This
TLV is sent in addition to any Application Priority TLV information received
from the configuration source. If the configuration source is sending iSCSI or
FCoE application priority information, it is not necessary to enable iscsi cos
to send the iSCSI Application Priority TLV.
Example
In the following example, iSCSI is globally enabled.
console(config)#iscsi enable
iscsi target port
Use the iscsi target port command in Global Configuration mode to
configure iSCSI port(s), target addresses and names. To delete iSCSI port(s)
or target ports, use the no form of this command.
Syntax
iscsi target port
tcp-port-1
[
tcp-port-2.… tcp-port-16
[ address
ip-address
]
[ name
targetname
]
no iscsi target port
tcp-port-1
[
tcp-port-2.… tcp-port-16
[ address
ip-address
]
•
tcp-port
—TCP port number or list of TCP port numbers on which iSCSI
target(s) listen to requests. Up to 16 TCP ports can be defined in the
system in one command or by using multiple commands.
•
ip-address
—IP address of the iSCSI target. When the no form is used, and
the tcp port to be deleted is one bound to a specific IP address, the address
field must be present.
•
targetname
—iSCSI name of the iSCSI target. The name can be statically
configured; however, it can be obtained from iSNS or from sendTargets
response. The initiator MUST present both its iSCSI Initiator Name and
the iSCSI Target Name to which it wishes to connect in the first login
request of a new session or connection. The target name can consist of any
printable character except for an exclamation point or a double quote as
2CSNXXX_SWUM200.book Page 540 Tuesday, December 10, 2013 1:22 PM