Dell Networking 2048, Справочное руководство

Страница: 1496 / 1823

1496
Management ACL Commands
deny (management)
Use the deny command in Management Access-List Configuration mode to
set conditions for the management access list.
Syntax
deny [ gigabitethernet unit/slot/port | vlan
vlan-id
| port-channel
port-
channel-number
| tengigabitethernet unit/slot/port | fortygigabitethernet
unit/slot/port] [ service
service
] [ priority
priority
]
deny ip-source
ip-address
[
mask
mask
|
prefix-length
] [
gigabitethernet
unit/slot/port |
vlan
vlan-id
|
port-channel port-channel-number
|
tengigabitethernet unit/slot/port | fortygigabitethernet unit/slot/port]
[ service
service
] [ priority
priority
]
• gigabitethernet unit/slot/port — A valid 1-gigabit Ethernet-routed port
number.
• vlan
vlan-id
— A valid VLAN number.
• port-channel
port-channel-number
— A valid routed port-channel
number.
• tengigabitethernet unit/slot/port — A valid 10-gigabit Ethernet-routed
port number.
• fortygigabitethernet unit/slot/port
–
A valid 40-gigabit Ethernet-routed
port number.
•
ip-address
— Source IP address.
•
mask mask
— Specifies the network mask of the source IP address.
•
mask prefix-length
— Specifies the number of bits that comprise the
source IP address prefix. The prefix length must be preceded by a forward
slash (/). (Range: 0–32)
• service
service
— Indicates service type. Can be one of the following:
telnet , ssh , http , https , tftp , snmp , sntp , or any . The any keyword indicates
that the service match for the ACL is effectively "don’t care".
• priority
priority
— Priority for the rule. (Range: 1–64)
management access-list show management access-list
2CSNXXX_SWUM200.book Page 1496 Tuesday, December 10, 2013 1:22 PM