Dell Networking 2048, Справочное руководство

Страница: 477 / 1823

IP Addressing Commands
477
21
IP Addressing Commands
Dell Networking N2000/N3000/N4000 Series Switches
Interfaces on the Dell Networking switches support a variety of capabilities to
support management of the switch. In addition to performing switching and
routing of network traffic, Dell Networking switches act as a host for
management of the switch. Commands in this category allow the network
operator to configure the local host address, utilize the embedded DHCP
client to obtain an address, resolve names to addresses using DNS servers, and
detect address conflicts on the local subnet.
There are two management interface types on Dell Networking switches. In-
band interfaces allow management of the switch through the network
switching/routing interfaces. Out-of-band management is always through the
dedicated out-of-band interface. The serial port on the stack master provides
a direct console interface supporting a CLI. In-band management interfaces
can employ a variety of protection mechanisms including VLAN assignment
and Management ACLs. The out-of-band port does not support such
protection mechanisms and, therefore, it is recommended that the out-of-
band interface only be connected to a physically segregated management
network.
Commands in this Chapter
This chapter explains the following commands:
clear host ip host
clear ip address-conflict-detect ip name-server
ip address (Out-of-Band) ipv6 address (Interface Configuration)
ip address-conflict-detect run ipv6 address dhcp
ip address dhcp (Interface Configuration) ipv6 enable (Interface Configuration)
ip default-gateway
show hosts
ip domain-lookup show ip address-conflict
ip domain-name show ip helper-address
2CSNXXX_SWUM200.book Page 477 Tuesday, December 10, 2013 1:22 PM