Installing LED board
1. Insert the LED board into the slot on the computer.
2. Tighten the M2.0 x 2.5 screw to secure the LED board.
3. Route the LED cable through the routing channel.
4. Connect the LED cable to the system board.
5. Connect the battery cable to the connector on the system board.
6. Follow the procedure in
After working inside your computer
.
Smart card module
Removing smart card cage
Before working inside your computer
.
2. Remove the
.
3. Disconnect the battery cable from the connector on the system board.
4. Remove the
.
5. To disconnect the smart card cable:
a. Disconnect the smart card cable [1].
NOTE:
Ensure to gently push the connector, to avoid damage to the smart card head.
b. Lift the smart card cable that is affixed to the touchpad module [2].
NOTE:
Ensure to pull gently to release it with adhesive tape.
6. To remove the smart card cage:
a. Remove the M2 x 3 screws (2) that secure the smart card cage to the computer [1].
28
Disassembly and reassembly
