Verifying system memory in Windows 10
1. Click on the start menu and select
Settings
>
System.
2. Under
System
, tap
About
.
Verifying system memory in system setup BIOS
1. Turn on or restart your system.
2. Perform the following actions after the Dell logo is displayed
●
With keyboard — Tap F2 until the Entering BIOS setup message appears. To enter the Boot selection menu, tap F12.
3. On the left pane, select
Settings
>
General
>
System Information
,
The memory information is displayed on the right pane.
Testing memory using ePSA
1. Turn on or restart your system.
2. Perform one of the following actions after the Dell logo is displayed:
●
With keyboard press
F12
.
●
The system displays one time boot menu and uses up and down arrow key to go to diagnostics and press enter to launch
ePSA.
The Pre Boot System Assessment (PSA) starts on your system.
NOTE:
If you wait too long and the operating system logo be displayed, continue to wait until you see the desktop. Turn
off the laptop and try again.
NOTE:
ePSA can alternatively be launched by pressing and holding
Fn
+
Press Power button
.
DDR4
DDR4 (double data rate fourth generation) memory is a higher-speed successor to the DDR2 and DDR3 technologies and allows
up to 512 GB in capacity, compared to the DDR3's maximum of 128 GB per DIMM. DDR4 synchronous dynamic random-access
memory is keyed differently from both SDRAM and DDR to prevent the user from installing the wrong type of memory into the
system.
DDR4 needs 20 percent less or just 1.2 volts, compared to DDR3 which requires 1.5 volts of electrical power to operate. DDR4
also supports a new, deep power-down mode that allows the host device to go into standby without needing to refresh its
memory. Deep power-down mode is expected to reduce standby power consumption by 40 to 50 percent.
DDR4 Details
There are subtle differences between DDR3 and DDR4 memory modules, as listed below.
Key notch difference
The key notch on a DDR4 module is in a different location from the key notch on a DDR3 module. Both notches are on the
insertion edge but the notch location on the DDR4 is slightly different, to prevent the module from being installed into an
incompatible board or platform.
Figure 1. Notch difference
58
Technology and components
Содержание Inspiron 3520
Страница 23: ...5 Slide and lift the keyboard away from the computer Disassembly and reassembly 23 ...
Страница 31: ...5 Remove the M2x3 screws and lift the system board away from the computer 1 2 Disassembly and reassembly 31 ...
Страница 40: ...6 Slide the display assembly away from the 40 Disassembly and reassembly ...