NOTE:
If the rubber grommets are pushed out of the speakers when removing the speakers, push them back in place
before replacing the speakers.
2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
3. Connect the speaker cable to the system board.
4. Connect the keyboard-backlight cable and the keyboard cable to the system board.
Next steps
1. Install the
.
2. Install the
.
3. Follow the procedure in
after working inside your computer
.
Heat sink
Removing the heat sink
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
About this task
CAUTION:
For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The oils in your
skin can reduce the heat transfer capability of the thermal grease.
NOTE:
The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to cool before you
touch it.
The following images indicate the location of the heat sink and provide a visual representation of the removal procedure.
Steps
1. In the reverse order (7>6>5>4>3>2>1), loosen the seven captive screws that secure the heat sink to the system board.
Removing and installing components
51