Steps
1. Place the display assembly on a clean and flat surface with the display panel facing up.
2. Slide the palm-rest and keyboard assembly under the display hinges.
3. Press down the display hinges and align the screw holes on the display hinges with the screw holes on the palm-rest and keyboard
assembly.
4. Replace the four screws (M2.5x5) that secure the display assembly to the palm-rest and keyboard assembly.
5. Align the display-cable connector on the system board, then firmly press into position.
Next steps
1. Install the
.
2. Follow the procedure in
after working inside your computer
.
I/O board
Removing the I/O board
Prerequisites
1. Follow the procedure in
before working inside your computer
2. Remove the
3. Remove the
.
About this task
The following images indicate the location of the I/O board and provide a visual representation of the removal procedure.
Steps
1. Peel the tape that secures the I/O-board cable to the I/O board.
2. Open the latch and disconnect the I/O-board cable from the I/O board.
3. Disconnect the fan cable from the I/O board.
4. Open the latch and disconnect the fingerprint-reader cable from the I/O board.
5. Remove the (M2x3) screw that secures the I/O board to the palm-rest and keyboard assembly.
Removing and installing components
43
