Option
Description
Sub NUMA Cluster
Enables or disables the Sub NUMA Cluster. This option is set to
EnabledDisabled
by default.
Logical Processor
Idling
Enables you to improve the energy efficiency of a system. It uses the operating system core parking algorithm and
parks some of the logical processors in the system which in turn allows the corresponding processor cores to
transition into a lower power idle state. This option can only be enabled if the operating system supports it. It is set
to
Disabled
by default.
Configurable TDP
Enables you to reconfigure the processor Thermal Design Power (TDP) levels during POST based on the power
and thermal delivery capabilities of the system. TDP verifies the maximum heat the cooling system is needed to
dissipate. This option is set to
Nominal
by default.
NOTE:
This option is only available on certain stock keeping units (SKUs) of the processors.
X2APIC Mode
Enables or disables the X2APIC mode. This option is set to
Disabled
by default.
Dell Controlled
Turbo
Controls the turbo engagement. Enable this option only when
System Profile
is set to
Performance
.
NOTE:
Depending on the number of installed CPUs, there might be up to two processor listings.
X2APIC Mode
Displays the X2APIC Mode setting that is read only and permanently set to enabled.
Number of Cores
per Processor
Controls the number of enabled cores in each processor. This option is set to
All
by default.
Processor Core
Speed
Specifies the maximum core frequency of the processor.
Processor n
NOTE:
Depending on the number of CPUs, there might be up to two processors listed.
The following settings are displayed for each processor installed in the system:
Option
Description
Family-Model-
Stepping
Specifies the family, model, and stepping of the processor as defined by Intel.
Brand
Specifies the brand name.
Level 2 Cache
Specifies the total L2 cache.
Level 3 Cache
Specifies the total L3 cache.
Number of Cores
Specifies the number of cores per processor.
SATA Settings
You can use the
SATA Settings
screen to view the SATA settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your
system.
Viewing SATA Settings
To view the
SATA Settings
screen, perform the following steps:
1
Turn on, or restart your system.
2
Press F2 immediately after you see the following message:
F2 = System Setup
42
Pre-operating system management applications
Содержание EMC PowerEdge C6420
