Installing the intrusion switch module
Prerequisites
1. Follow the safety guidelines listed in the
on page 23.
2. Follow the procedure listed in
Before working inside your system
3.
Remove the expansion card riser
.
NOTE:
Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped.
Steps
1. Align the guides on the intrusion switch module with the standoffs on the system.
2. Slide the intrusion switch module into the slot in the system until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the screw on the intrusion switch module.
4. Connect the intrusion switch cable to the connector on the rear I/O board.
Figure 97. Installing the intrusion switch module
Next steps
1.
Install the expansion card riser
.
2. Follow the procedure listed in
After working inside your system
on page 24.
Optional OCP card
Removing the OCP card
Prerequisites
1. Follow the safety guidelines listed in the
on page 23.
2. Follow the procedure listed in the
Before working inside your system
3.
Remove the expansion card riser
.
Installing and removing system components
91
