Figure 93. Installing the M.2 SSD module
Next steps
1. Install the BOSS card. Installing the BOSS is similar to
installing expansion card into the expansion card riser
.
2. Follow the procedure listed in the
After working inside your system
on page 24.
System battery
Replacing the system battery
Prerequisites
WARNING:
There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only
with the same or equivalent type that is recommended by the manufacturer. Discard used batteries according to
the manufacturer's instructions. See the Safety instructions, that came with your system for more information.
1. Follow the safety guidelines listed in the
on page 23.
2. Follow the procedure listed in the
Before working inside your system
3. If applicable, disconnect the power or data cables from the expansion cards.
4.
Remove the expansion card risers
Steps
1. To remove the battery:
a. Use a plastic scribe to pry out the system battery.
CAUTION:
To avoid damage to the battery connector, you must firmly support the connector while installing
or removing a battery.
88
Installing and removing system components
