Figure 81. Installing the expansion card riser (Riser 3)
Next steps
1. If required, connect the cables to the expansion card or the risers.
2. Follow the procedure listed in
After working inside your system
on page 24.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
on page 23.
2. Follow the procedure listed in the
Before working inside your system
3. If applicable, disconnect the cables from the expansion card.
4.
Remove the expansion card riser
.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Pull the black card holder before removing the card from the Riser 1.
3. Hold the expansion card by the edges, and pull the card until the card edge connector disengages from the expansion card
connector on the Riser 1.
NOTE:
The procedure is similar for Riser 4.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
80
Installing and removing system components
