6.
Stop scanning after the Bluetooth keyboard is found.
$ scan off
7.
Pair Bluetooth devices.
$ pair
<MAC address of Bluetooth keyboard>
8.
Enter PIN code on the Bluetooth keyboard, if required.
9.
Trust the Bluetooth keyboard.
$ trust
<MAC address of Bluetooth keyboard>
10. Connect to the Bluetooth keyboard.
$ connect
<MAC address of Bluetooth keyboard>
11. Close the bluetoothctl console.
$ quit
You can start using the Bluetooth keyboard.
Switching between WLAN and Bluetooth modes
1.
Unload the WLAN/BT driver.
$ modprobe -r ven_rsi_sdio
2.
Adjust the mode in /etc/modprobe.d/rs9113.conf
3.
Reload the WLAN/BT driver.
$ modprobe ven_rsi_sdio
4.
Verify the operation mode. Refer to the table for operating mode values.
$ cat /sys/module/ven_rsi_sdio/parameters/dev_oper_mode
Table 8. Operating mode values for WLAN and Bluetooth
Operating mode value
WiFi station
BT/BLE modes supported softAP
Clients supported by
softAP
1
X
N/A
N/A
1
N/A
X
32
13
X
Dual (BT classic and
BTLE)
N/A
14
Dual (BT classic and
BTLE)
X
4
5
X
BT Classic
N/A
6
BT Classic
X
32
Software enabled Access Point (SoftAP)
The Software enabled Access Point (SoftAP) feature depends on the Wi-Fi card and associated driver support to act as a wireless access
point.
Run the following commands:
1.
Check the access point status.
$ wifi-ap.status
2.
By default, SoftAP is disabled. Turn on SoftAP.
$ wifi-ap.config set disabled=false
3.
To secure the Wi-Fi access point with WPA2 personal, change two configuration items.
$ wifi-ap.config set wifi.security=wpa2 wifi.security-passphrase=Test1234
This enables WPA2 security with the passphrase set to
Test1234
.
NOTE: If the passphrase contains any special characters or space, ensure that it is added correctly. For example 'My WiFi', 'Pa
$$word', or "Alan's AP".
53